← Back to Patlo Sealer
Request Bulk Quote
RHR & Company

Official Technical Data Sheet

Patlo Sealer

Premium Sealer & Waterproofer

Category: Waterproofing

Classification: Deep-Penetrating Breathable Sealer

Document Ref: TDS-RHR-011

1. Product Description

A specialized sealer formulated to penetrate deep into surfaces.

Key Performance Advantages:

  • ✓ Anti-Efflorescence (Kalar) Defense: Blocks salt migration and white powdery efflorescence common in coastal Karachi & Sindh masonry.
  • ✓ Deep Pore Penetration: Seals capillary pores from within while allowing trapped vapor to escape naturally.
  • ✓ Multi-Size Project Packs: Available in 1kg, 2kg, 5kg, and 10kg packs for residential repairs up to commercial towers.
  • ✓ Brush, Roller, or Spray Ready: Fast coverage across plastered walls, fair-face concrete, stone cladding, and brick.
Patlo Sealer

2. Technical & Physical Properties

Standard Packaging 1, 2, 5, 10 kg Packs
Type Penetrating Sealer
Application Method Brush, Roller, or Spray

3. Site Surface Preparation & Application Method

Step 1: Substrate Cleaning

Remove all dust, laitance, oil, peeling paint, and salt efflorescence by wire-brushing. Repair honeycombs or cracks >2mm before coating.

Step 2: Pre-Dampening / Priming

Lightly dampen absorbent concrete or plaster surfaces with clean water to SSD (saturated surface-dry) condition with no standing puddles.

Step 3: First Protective Coat

Apply the first uniform coat using a stiff brush, roller, or trowel (for Readymix Patlo), working thoroughly into corners, coves, and pipe penetrations.

Step 4: Cross-Coat & Flood Test

Once touch-dry (2–4 hours), apply the second coat at a 90° perpendicular angle. Allow 24–48 hours cure before flood testing or tiling.

Health & Safety

Cementitious and chemical construction products are alkaline when mixed with water. Wear protective gloves and safety eyewear during mixing and application. Wash splashes from skin or eyes immediately with clean water.

Technical Note

Values stated are typical application figures under normal site conditions (25–30°C). Site temperature and substrate porosity may affect open time and coverage. Technical site guidance is available on bulk commercial orders.