← Back to Mapro White Cement
Request Bulk Quote
RHR & Company

Official Technical Data Sheet

Mapro White Cement

Brilliant White Cement for Pointing

Category: Finishing

Classification: White Portland Cement (>42.5 N/mm²)

Document Ref: TDS-RHR-014

1. Product Description

High-purity white Portland cement for tile pointing and decorative grout work.

Key Performance Advantages:

  • ✓ >90 Brilliant Whiteness Index: Pure bright-white finish for visible tile pointing, marble joints, mosaic work, and decorative renders.
  • ✓ >42.5 MPa Structural Strength: True White Portland Cement achieving high 28-day compressive strength without chalking.
  • ✓ Pigment-Friendly Base: Blends cleanly with oxide pigments for custom terrazzo, mosaic, and architectural finishes.
  • ✓ 1kg Sealed Retail & Site Pouch: Zero clumping or moisture spoilage compared to loose open cement bags on site.
Mapro White Cement

2. Technical & Physical Properties

Standard Packaging 1KG Pouch
Color Brilliant White (Whiteness > 90)
Water Ratio 0.45 - 0.50 per kg
Initial Set 45 Minutes (minimum)
Final Set 10 Hours (maximum)
Compressive Strength (28d) > 42.5 N/mm²
Application Pointing, Rendering, White Grout
Shelf Life 12 Months (in dry conditions)

3. Site Surface Preparation & Application Method

Step 1: Surface Preparation

Ensure masonry, concrete, or ceiling surface is sound and free from dust, form-release oil, grease, and loose mortar particles.

Step 2: Clean Water Mixing

Mix Mapro Cement with clean water (0.45–0.50 ratio) or graded fine aggregate/pigment to achieve a cohesive, workable mortar paste.

Step 3: Trowel / Float Application

Press firmly into tile joints, pointing lines, or repair patches using a steel trowel or pointing tool, compacting thoroughly.

Step 4: Finishing & Curing

Strike off excess material cleanly with a damp sponge and mist-cure cementitious repairs for 3–7 days to maximize 28-day strength.

Health & Safety

Cementitious and chemical construction products are alkaline when mixed with water. Wear protective gloves and safety eyewear during mixing and application. Wash splashes from skin or eyes immediately with clean water.

Technical Note

Values stated are typical application figures under normal site conditions (25–30°C). Site temperature and substrate porosity may affect open time and coverage. Technical site guidance is available on bulk commercial orders.