← Back to ReadyMix Tile Bond
Request Bulk Quote
RHR & Company

Official Technical Data Sheet

ReadyMix Tile Bond

High-Performance C2 Grade Tile Adhesive

Category: Tile Adhesives

Classification: Waterproof C2 Polymer Adhesive

Document Ref: TDS-RHR-001

1. Product Description

ReadyMix Tile Bond (C2) is a premium cement-based tile adhesive designed for strong, durable, and long-lasting tile installations.

Key Performance Advantages:

  • ✓ Waterproof: resists water penetration, suitable for bathrooms, kitchens, and pool surrounds
  • ✓ Heat & weather resistant: performs reliably in exterior applications and extreme temperatures
  • ✓ High adhesive strength: 21.5 KN/m peeloff strength for long-lasting bond on walls and floors
  • ✓ Crack resistant: polymer modification limits shrinkage cracking common in standard cement adhesives
  • ✓ Non-shrinkage formula: maintains dimensional stability after curing
  • ✓ Versatile use: bonds ceramic, imported tiles, marble, granite, and decorative cladding
ReadyMix Tile Bond

2. Technical & Physical Properties

Appearance Grey powder
Composition OPC cement, selected silica aggregate, polymer additives
Maximum aggregate size 1.0 mm
Water required 25–30% (approx. 5–6 litres per 20 kg bag)
Compressive strength 1.25 N/mm² at 28 days
Peel-off strength 21.5 KN/m
Pot life Approx. 2 hours at 30°C
Coverage 30–35 sq. ft per 20 kg bag at 3–5mm thickness
Packaging 20 kg plastic bag
Shelf life 6 months in original, unopened packaging
Storage Store in a dry, cool place below 35°C, away from direct sunlight

3. Site Surface Preparation & Application Method

Step 1: Surface Preparation

Ensure the concrete, screed, or plaster substrate is cured, flat, structurally sound, and free from dust, oil, loose laitance, or curing compounds.

Step 2: Mechanical Mixing

Gradually add the 20kg bag of RHR Tile Bond to 5–6 liters of clean water. Mix with a slow-speed drill mixer until a smooth, lump-free paste forms; slake 5 minutes and remix.

Step 3: Notched Trowel Combing

Key a thin contact layer onto the substrate with the flat edge of the trowel, then comb uniform ribs at a 45° angle using a notched trowel (3–5mm bed).

Step 4: Bedding & Grouting

Press tiles firmly into wet adhesive ribs with a slight twisting motion for 100% back-butter coverage on large formats. Allow 24 hours cure before grouting.

Health & Safety

Cementitious and chemical construction products are alkaline when mixed with water. Wear protective gloves and safety eyewear during mixing and application. Wash splashes from skin or eyes immediately with clean water.

Technical Note

Values stated are typical application figures under normal site conditions (25–30°C). Site temperature and substrate porosity may affect open time and coverage. Technical site guidance is available on bulk commercial orders.