← Back to Strong Hi-Mix Grout
Request Bulk Quote
RHR & Company

Official Technical Data Sheet

Strong Hi-Mix Grout

High-Strength Sanded Grout for Wide Joints

Category: Grouts

Classification: Sanded Wide-Joint Tile Grout

Document Ref: TDS-RHR-008

1. Product Description

A cement-based, sanded grout engineered for joints from 2-12mm.

Key Performance Advantages:

  • ✓ Wide Joint Engineering (2–12mm): Graded silica sand reinforcement eliminates shrinkage cracking in wide commercial and exterior joints.
  • ✓ High Compressive Strength (>20 MPa): Withstands heavy foot traffic, shopping trolleys, and commercial floor maintenance equipment.
  • ✓ 24 Fade-Resistant Colours: Extensive palette of 24 fade-resistant colours for indoor floors, terraces, and facades.
  • ✓ Chemical & Abrasion Resistant: Dense sanded formulation built to withstand commercial floor scrubbing and mild cleaning agents.
Strong Hi-Mix Grout

2. Technical & Physical Properties

Standard Packaging 1KG Pouch
Available Colors 24 Colours
Type Sanded Cementitious Grout
Joint Width 2 - 12 mm
Water Ratio 0.25 - 0.30 L per 1 kg
Pot Life Approx. 60 Minutes
Open Time 15 - 20 Minutes
Compressive Strength > 20 N/mm²
Shelf Life 12 Months (in dry conditions)

3. Site Surface Preparation & Application Method

Step 1: Joint Preparation

Ensure tile adhesive has cured for at least 24 hours. Rake out all spacer clips, dust, excess adhesive, and standing water from tile joints.

Step 2: Proportionate Mixing

Add grout powder gradually to clean water per the Technical Data Sheet ratio. Mix to a smooth, lump-free creamy paste and let slake for 3 minutes.

Step 3: Diagonal Float Application

Work grout firmly into joints using a rubber grout float held at a 45° angle, moving diagonally across tiles to pack joints completely.

Step 4: Sponge Clean & Cure

After 15–20 minutes as surface haze forms, wipe diagonally with a damp (not dripping) sponge. Polish dry haze with a microfiber cloth after 24 hours.

Health & Safety

Cementitious and chemical construction products are alkaline when mixed with water. Wear protective gloves and safety eyewear during mixing and application. Wash splashes from skin or eyes immediately with clean water.

Technical Note

Values stated are typical application figures under normal site conditions (25–30°C). Site temperature and substrate porosity may affect open time and coverage. Technical site guidance is available on bulk commercial orders.