← Back to Stylo Plus Tile Bond
Request Bulk Quote
RHR & Company

Official Technical Data Sheet

Stylo Plus Tile Bond

Polymer Modified Cementitious Tile Adhesive

Category: Tile Adhesives

Classification: Anti-Slip Polymer Tile Adhesive

Document Ref: TDS-RHR-003

1. Product Description

Polymer modified cement based tile adhesive offering good adhesion and consistent performance for general ceramic tile fixing on floors and walls.

Key Performance Advantages:

  • ✓ Polymer Modified Formula: Good adhesion for standard ceramic tile fixing.
  • ✓ Consistent Performance: Efficient, predictable results across general tiling jobs.
  • ✓ Smooth Workability: Easy to spread and handle on site.
  • ✓ Suitable for Floors and Walls: Versatile for general interior applications.
Stylo Plus Tile Bond

2. Technical & Physical Properties

Type Polymer Modified Cementitious Tile Adhesive
Appearance Grey powder
Composition OPC cement, graded sand, polymer additives
Water required 25–30% (approx. 5–6 litres per 20 kg bag)
Compressive strength ~1.0 N/mm² @ 28 days
Peel-off strength ~15 KN/m
Pot life Approx. 1.5 hours at 30°C
Coverage 30–35 sq. ft per 20 kg bag at 3–5mm thickness
Packaging 20 kg Paper Bag
Shelf life 6 months in original, unopened packaging
Storage Store in a dry, cool place below 35°C, away from direct sunlight

3. Site Surface Preparation & Application Method

Step 1: Surface Preparation

Ensure the concrete, screed, or plaster substrate is cured, flat, structurally sound, and free from dust, oil, loose laitance, or curing compounds.

Step 2: Mechanical Mixing

Gradually add the 20kg bag of RHR Tile Bond to 5–6 liters of clean water. Mix with a slow-speed drill mixer until a smooth, lump-free paste forms; slake 5 minutes and remix.

Step 3: Notched Trowel Combing

Key a thin contact layer onto the substrate with the flat edge of the trowel, then comb uniform ribs at a 45° angle using a notched trowel (3–5mm bed).

Step 4: Bedding & Grouting

Press tiles firmly into wet adhesive ribs with a slight twisting motion for 100% back-butter coverage on large formats. Allow 24 hours cure before grouting.

Health & Safety

Cementitious and chemical construction products are alkaline when mixed with water. Wear protective gloves and safety eyewear during mixing and application. Wash splashes from skin or eyes immediately with clean water.

Technical Note

Values stated are typical application figures under normal site conditions (25–30°C). Site temperature and substrate porosity may affect open time and coverage. Technical site guidance is available on bulk commercial orders.